Command Line Interface Guide

354 DHCP Layer 2 Relay Commands
Parameter Description
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode, Config mode and all Config sub-modes
User Guidelines
There are no user guidelines for this command.
Example
console#show dhcp l2relay remote-id vlan 200
DHCP L2 Relay is Enabled.
VLAN ID Remote Id
---------------------
200remote_22
clear dhcp l2relay statistics interface
Use the show dhcp l2relay statistics interface command in Privileged EXEC
mode to reset the DHCP L2 Relay counters to zero. Specify the port with the
counters to clear, or use the all keyword to clear the counters on all ports.
Syntax
clear dhcp l2relay statistics interface {all | interface-id }
Parameter Description
vlan-range Show information for the specified VLAN range. A range may
be a single VLAN ID or two VLAN IDs separated by a single
dash with no embedded spaces.
2CSPC4.X8100-SWUM100.book Page 354 Wednesday, August 29, 2012 6:23 PM