Command Line Interface Guide

394 Dynamic ARP Inspection Commands
---- ---------- ---------- ---------- ---------- ----
------ ---------- ------
10 11 1 65 25
1 1 0
20 1 0 8 2
0 1 1
show ip arp inspection vlan
Use the show ip arp inspection vlan command to display the Dynamic ARP
Inspection configuration on all the VLANs in the given VLAN range. It also
displays the global configuration values for source MAC validation,
destination MAC validation and invalid IP validation.
Syntax
show ip arp inspection vlan [ vlan-range ]
Parameter Description
Default Configuration
There is no default configuration for this command.
Command Mode
Privileged EXEC mode, Config mode and all Config sub-modes
User Guidelines
The following global parameters are displayed:
Parameter Description
vlan-range A valid VLAN range.
Parameter Description
Source Mac Validation If Source Mac validation of ARP frame is enabled.
2CSPC4.X8100-SWUM100.book Page 394 Wednesday, August 29, 2012 6:23 PM