Command Line Interface Guide

420 Ethernet Configuration Commands
Example
The following example shows how gigabitethernet ports 5/0/18 to 5/0/20 and
3/0/1 to 3/0/24 are ranged to receive the same command.
console(config)# interface range gigabitethernet
5/0/18-20,3/0/1-24
console(config-if-range)#
The following example shows how all gigabitethernet ports can be configured
at once.
console(config)# interface range gigabitethernet all
console(config-if-range)#
The following examples demonstrate various valid interface ranges:
console(config)#interface range gigabitEthernet
1/0/1-20
console(config)#interface range gi1/0/20-48
console(config)#interface range gi1/0/1,gi1/0/48
console(config)#interface range gi2/0/1-10,gi1/0/30
console(config)#interface range gi1/0/1-10,gi1/0/30-
48
console(config)#interface range gi1/0/1,te1/1/1
console(config)#interface range gigabitEthernet
1/0/10,tengigabitEthernet 1/1/2
mtu
Use the mtu command in Interface Configuration mode to set the maximum
transmission unit on an interface by adjusting the maximum size of received
Ethernet frames. To return to the default setting, use the no form of this
command.
2CSPC4.X8100-SWUM100.book Page 420 Wednesday, August 29, 2012 6:23 PM