Command Line Interface Guide

424 Ethernet Configuration Commands
show interfaces configuration
Use the show interfaces configuration command in User EXEC mode to
display the configuration for all configured interfaces.
Syntax
show interfaces configuration [{gigabitethernet unit/slot/port| port-channel
port-channel-number | tengigabitethernet unit/slot/port |
fortygigabitethernet
unit/slot/port}]
Default Configuration
This command has no default configuration.
Command Mode
User EXEC mode, Config mode and all Config sub-modes
User Guidelines
This command has no use guidelines.
Example
The following example displays the configuration for all configured
interfaces:
console>show interfaces configuration
Port Type Duplex Speed Neg Admin
State
----- ------------------------------ ------ ------- ---- -----
1/0/1 Gigabit - Level Full 100 Auto Up
1/0/2 Gigabit - Level N/A Unknown Auto Up
1/0/3 Gigabit - Level N/A Unknown Auto Up
1/0/4 Gigabit - Level N/A Unknown Auto Up
1/0/5 Gigabit - Level N/A Unknown Auto Up
1/0/6 Gigabit - Level N/A Unknown Auto Up
1/0/7 Gigabit - Level N/A Unknown Auto Up
1/0/8 Gigabit - Level N/A Unknown Auto Up
2CSPC4.X8100-SWUM100.book Page 424 Wednesday, August 29, 2012 6:23 PM