Command Line Interface Guide

Ethernet Configuration Commands 425
1/0/9 Gigabit - Level N/A Unknown Auto Up
1/0/10 Gigabit - Level N/A Unknown Auto Up
1/0/11 Gigabit - Level N/A Unknown Auto Up
1/0/12 Gigabit - Level N/A Unknown Auto Up
1/0/13 Gigabit - Level N/A Unknown Auto Up
1/0/14 Gigabit - Level N/A Unknown Auto Up
1/0/15 Gigabit - Level N/A Unknown Auto Up
1/0/16 Gigabit - Level N/A Unknown Auto Up
1/0/17 Gigabit - Level N/A Unknown Auto Up
1/0/18 Gigabit - Level N/A Unknown Auto Up
1/0/19 Gigabit - Level N/A Unknown Auto Up
--More-- or (q)uit
The displayed port configuration information includes the following:
show interfaces counters
Use the show interfaces counters command in either User EXEC mode or
Privileged EXEC mode to display Priority Flow Control (PFC) traffic seen by
the interface, including Received PFC Frames and Transmitted PFC Frames
for a given ethernet or port-channel interface.
Field Description
Port The port number.
Port Type The port designated IEEE shorthand identifier. For example
1000Base-T refers to 1000 Mbps baseband signaling including both
Tx and Rx transmissions.
Duplex Displays the port Duplex status.
Speed Refers to the port speed.
Neg Describes the Auto-negotiation status.
Admin State Displays whether the port is enabled or disabled.
2CSPC4.X8100-SWUM100.book Page 425 Wednesday, August 29, 2012 6:23 PM