Command Line Interface Guide

IP Addressing Commands 509
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode
User Guidelines
This command has no user guidelines.
Example
console#
console#configure
console(config)#clear ip address-conflict-detect
ip address (Out-of-Band)
Use the ip address command in Interface Configuration mode to set an IP
address for the out-of-band interface. Use the no form of this command to
return the ip address configuration to its default value.
Syntax
ip address { ip-address { mask | prefix-length } | dhcp}
no ip address
Parameter Description
Parameter Description
ip-address Specifies a valid IP address.
mask Specifies a valid subnet (network) mask IP address.
prefix-length The number of bits that comprise the IP address prefix. The
prefix length must be preceded by a forward slash (/). (Range: 1-
30 bits)
dhcp Obtain the out-of-band interface
address via DHCPv4.
2CSPC4.X8100-SWUM100.book Page 509 Wednesday, August 29, 2012 6:23 PM