Command Line Interface Guide

IP Addressing Commands 521
ipv6 enable (Interface Config)
Use the ipv6 enable command in Interface Config mode to enable IPv6 on a
routing interface. Use the no form of this command to reset the IPv6
configuration to the defaults.
Syntax
ipv6 enable
no ipv6 enable
Default Configuration
IPv6 is not enabled by default.
Command Mode
Interface Configuration mode (VLAN, loopback)
User Guidelines
There are no user guidelines for this command.
Example
console(config)#no ipv6 enable
ipv6 enable (OOB Config)
Use the ipv6 enable command in Interface (out-of-band) Config mode to
enable IPv6 operation on the out-of-band interface. Prefixes configured by
the ipv6 address command are not configured until the interface is enabled.
Syntax
ipv6 enable
no ipv6 enable
Default Configuration
By default, IPv6 is not enabled on the out-of-band port.
2CSPC4.X8100-SWUM100.book Page 521 Wednesday, August 29, 2012 6:23 PM