Command Line Interface Guide

522 IP Addressing Commands
Command Mode
Interface (out-of-band) Configuration mode
User Guidelines
There are no user guidelines for this command.
ipv6 gateway (OOB Config)
Use the ipv6 gateway command in Interface (out-of-band) Config mode to
configure the address of the IPv6 gateway. The gateway is used as a default
route for packets addressed to network devices not present on the local
subnet. Use the no form of the command to remove the gateway
configuration.
Syntax
ipv6 gateway ipv6-address
no ipv6 gateway
Parameter Description
Default Configuration
By default, no IPv6 gateway is configured.
Command Mode
Interface (out-of-band) Configuration mode
User Guidelines
There are no user guidelines for this command.
Parameter Description
ipv6-address An IPv6 address (not a prefix).
2CSPC4.X8100-SWUM100.book Page 522 Wednesday, August 29, 2012 6:23 PM