Command Line Interface Guide

546 IPv6 MLD Snooping Commands
Default Configuration
This command has no default configuration
Command Mode
Privileged EXEC mode, Config mode and all Config sub-modes
User Guidelines
This command has no user guidelines.
Example
With no optional arguments, the command displays the following
information:
• Admin Mode — Indicates whether or not MLD Snooping is active on the
switch.
• Interfaces Enabled for MLD Snooping — Interfaces on which MLD
Snooping is enabled.
• MLD Control Frame Count — This displays the number of MLD control
frames that are processed by the CPU.
• VLANs Enabled for MLD Snooping — VLANs on which MLD Snooping is
enabled.
When you specify an interface or VLAN, the following information displays:
• MLD Snooping Admin Mode — Indicates whether MLD Snooping is
active on the interface or VLAN.
• Fast Leave Mode — Indicates whether MLD Snooping Fast-leave is active
on the VLAN.
• Group Membership Interval — Shows the amount of time in seconds that
a switch will wait for a report from a particular group on a particular
interface, which is participating in the VLAN, before deleting the interface
from the entry. This value may be configured.
• Max Response Time — Displays the amount of time the switch waits after
it sends a query on an interface, participating in the VLAN, because it did
not receive a report for a particular group on that interface. This value may
be configured.
2CSPC4.X8100-SWUM100.book Page 546 Wednesday, August 29, 2012 6:23 PM