Command Line Interface Guide

580 Link Dependency Commands
Examples
console(config-linkDep-group-1)#depends-on
gigabitethernet 1/0/10
console(config-linkDep-group-1)#depends-on port-
channel 6
show link-dependency
Use the show link-dependency command to show the link dependencies
configured for a particular group. If no group is specified, then all the
configured link-dependency groups are displayed.
Syntax
show link-dependency [ group GroupId ] [detail]
Parameter Description
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC, Config mode and all Config sub-modes
User Guidelines
No specific guidelines
Example
The following command shows link dependencies for all groups.
console#show link-dependency
Parameter Description
GroupID Link dependency group identifier. (Range: Valid Group Id,
1–16)
detail Show detailed information about the state of members and the
dependent ports.
2CSPC4.X8100-SWUM100.book Page 580 Wednesday, August 29, 2012 6:23 PM