Command Line Interface Guide

610 Multicast VLAN Registration Commands
Command Mode
Interface Config
User Guidelines
This command statically configures a port to receive the specified multicast
group on the specified VLAN. This command only applies to receiver ports in
compatible mode. It also applies to source ports in dynamic mode. In
dynamic mode, receiver ports can also join multicast groups using IGMP
messages.
Example
console(config-if-Gi1/0/1)#interface Te1/1/1
console(config-if-Gi1/0/24)#switchport mode trunk
console(config-if-Gi1/0/24)#switchport trunk native
vlan 2000
console(config-if-Gi1/0/24)#switchport trunk allowed
vlan add 2000
console(config-if-Gi1/0/24)#mvr
console(config-if-Gi1/0/24)#mvr type source
console(config-if-Gi1/0/24)#mvr vlan 2000 group
239.1.1.1
show mvr
Use the show mvr command in Privileged EXEC mode to display global MVR
settings.
Syntax
show mvr
Parameter Description
The following table explains the output parameters.
2CSPC4.X8100-SWUM100.book Page 610 Wednesday, August 29, 2012 6:23 PM