Command Line Interface Guide

614 Multicast VLAN Registration Commands
The following table explains the output parameters.
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC, Config mode and all Config sub-modes
User Guidelines
The following table lists the completion messages.
Examples
console#show mvr interface
VID VLAN identifier.
Parameter Description
Port Interface number
Type The MVR port type. It can be None,
Receiver, or Source type.
Status The interface status. It consists of two
characteristics:
1 active or inactive indicating if port is
forwarding.
2 inVLAN or notInVLAN indicating if the
port is part of any VLAN
Immediate Leave The state of immediate mode. It can be
enabled or disabled.
Message Type Message Description
Successful Completion Message None
Error Completion Message MVR disabled
Parameter Description
2CSPC4.X8100-SWUM100.book Page 614 Wednesday, August 29, 2012 6:23 PM