Command Line Interface Guide

QoS Commands 655
• ip-dscp — Specifies that the mode be set to trust IP DSCP packet
markings.
Default Configuration
This command has no default configuration.
Command Mode
Global Configuration mode or Interface Configuration (gigabitethernet,
port-channel, tengigabitethernet
, fortygigabitethernet) mode
User Guidelines
This command has no user guidelines.
Examples
The following example displays how you set the class of service trust mode of
an interface to trust dot1p (802.1p) packet markings when in Global
Configuration mode.
console(config)#classofservice trust dot1p
The following example displays how you set the class of service trust mode of
an interface to trust IP Precedence packet mark
console(config)#classofservice trust ip-precedence
conform-color
Use the conform-color command in Policy-Class-Map Configuration mode
to specify second-level matching for traffic flow, the only possible actions are
drop, setdscp-transmit, set-prec-transmit, or transmit. In this two-rate form
of the policy command, the conform action defaults to send, the exceed
action defaults to drop, and the violate action defaults to drop. These actions
can be set with this command.
Syntax
conform-color
2CSPC4.X8100-SWUM100.book Page 655 Wednesday, August 29, 2012 6:23 PM