Command Line Interface Guide

QoS Commands 687
console#show class-map stop_http_class
Class Name.....................................
stop_http_class
Class Type..................................... All
Class Layer3 Protocol.......................... ipv6
Match Criteria Values
---------------------------- ------------------------
-------------
Source IP Address 2001:DB8::/32
Source Layer 4 Port 80(http/www)
show classofservice dot1p-mapping
Use the show classofservice dot1p-mapping command in Privileged EXEC
mode to display the current Dot1p (802.1p) priority mapping to internal
traffic classes for a specific interface.
Syntax
show classofservice dot1p-mapping [{gigabitethernet unit/slot/port | port-
channel
port-channel-number | tengigabitethernet unit/slot/port |
fortygigabitethernet unit/slot/port}]
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode, Config mode and all Config sub-modes
2CSPC4.X8100-SWUM100.book Page 687 Wednesday, August 29, 2012 6:23 PM