Command Line Interface Guide

708 RADIUS Commands
• FILTER-ID
– Name of the filter list for this user.
• TUNNEL-TYPE
– Used to indicate that a VLAN is to be assigned to the user when set to
tunnel type VLAN (13).
• TUNNEL-MEDIUM-TYPE
– Used to indicate the tunnel medium type. Must be set to medium
type 802 (6) to enable VLAN assignment.
• TUNNEL-PRIVATE-GROUP-ID
– Used to indicate the VLAN to be assigned to the user. May be a string
which matches a preconfigured VLAN name or a VLAN id. If a VLAN
id is given, the string must only contain decimal digits.
Commands in this Chapter
This chapter explains the following commands:
aaa accounting dot1x
default start-stop
primary radius-server timeout
accounting priority retransmit
acct-port radius-server attribute 4 show aaa servers
auth-port radius-server deadtime show accounting methods
deadtime radius-server host show accounting methods
debug aaa accounting radius-server key source-ip
debug aaa accounting radius-server retransmit timeout
msgauth radius-server source-ip usage
name (RADIUS server)
––
2CSPC4.X8100-SWUM100.book Page 708 Wednesday, August 29, 2012 6:23 PM