Command Line Interface Guide

VLAN Commands 797
dvlan-tunnel ethertype
Use the dvlan-tunnel ethertype command in Global Configuration mode to
enable the configuration of the inner and outer VLAN tag ethertype.
To configure the EtherType to its default value, use the no form of this
command.
Syntax
dvlan-tunnel ethertype {802.1Q | vman | custom 0-65535 [primary-tpid] }
no dvlan-tunnel ethertype
Parameter Description
protocol vlan group
all
switchport
forbidden vlan
vlan association
mac
–
show dvlan-tunnel switchport general
acceptable-frame-
type tagged-only
vlan association
subnet
–
Private VLAN Commands
switchport private-
vlan
private-vlan show interfaces
switchport
show vlan private-vlan
switchport mode
private-vlan
–––
Parameter Description
802.1Q Configures the EtherType as 0x8100.
vman Configures the EtherType as 0x88A8
custom Configures a custom EtherType for the DVLAN tunnel. The
value must be 0-65535.
primary-tpid Globally configures the tag protocol identifier on the outer
VLAN tag (S-TAG). If this parameter is not given, the inner
vlan (C-TAG) is configured.
2CSPC4.X8100-SWUM100.book Page 797 Wednesday, August 29, 2012 6:23 PM