Command Line Interface Guide

VLAN Commands 799
Parameter Description
Default Configuration
By default, routing is enabled on VLAN 1.
Command Mode
VLAN Configuration or Global Configuration modes
User Guidelines
The nsf-index parameter is automatically assigned by the system for
synchronizing routing information across a stack. Assigning an incorrect index
via the CLI will result in an error.
Examples
console(config-vlan10)# interface vlan 10
console(config-if-vlan10)#
interface range vlan
Use the interface range vlan command in Global Configuration mode to
execute a command on multiple VLANs at the same time.
Syntax
interface range vlan { vlan-range | all }
Parameter Description
vlan-id The ID of a valid VLAN (Range 1–4093).
nsf-index Internal interface ID. This optional parameter is automatically
generated by the system and does not need to be entered by the
user. The nsf-index parameter is listed in the configuration file
and the running configuration for all VLAN routing interfaces.
When a nonstop forwarding failover occurs, the nsf-index
enables the system to correlate checkpointed state information
with the proper internal interfaces.
2CSPC4.X8100-SWUM100.book Page 799 Wednesday, August 29, 2012 6:23 PM