Command Line Interface Guide

800 VLAN Commands
• vlan-range — A list of valid VLAN IDs to add. Separate nonconsecutive
VLAN IDs with a comma and no spaces; use a hyphen to designate a range
of IDs. (Range: 2–4093)
•
all — All existing static VLANs.
Default Configuration
This command has no default configuration.
Command Mode
Global Configuration mode
User Guidelines
Commands used in the interface range context are executed independently
on each interface in the range. If the command returns an error on one of the
interfaces, an error message is displayed and execution continues on other
interfaces.
Example
The following example groups VLAN 221 till 228 and VLAN 889 to receive
the same command.
console(config)#interface range vlan 221-228,889
console(config-if)#
mode dvlan-tunnel
Use the mode dvlan-tunnel command in Interface Configuration mode to
enable Double VLAN Tunneling on the specified interface. To disable Double
VLAN Tunneling on the specified interface, use the no form of this
command.
Syntax
mode dvlan-tunnel
no mode dvlan-tunnel
2CSPC4.X8100-SWUM100.book Page 800 Wednesday, August 29, 2012 6:23 PM