Command Line Interface Guide

VLAN Commands 801
Default Configuration
By default, Double VLAN Tunneling is disabled .
Command Mode
Interface Configuration (gigabitethernet, port-channel, tengigabitethernet,
fortygigabitethernet) mode
User Guidelines
Use the global configuration command dvlan-tunnel ethertype to configure
the inner and outer TPIDs.
Example
The following example displays how to enable Double VLAN Tunneling at
gigabit ethernet port 1/0/1.
console(config-if-1/0/1)#mode dvlan-tunnel
name (VLAN Configuration)
Use the name command in VLAN Configuration mode to configure the
VLAN name. To return to the default configuration, use the no form of this
command.
NOTE: This command cannot be configured for a range of interfaces (range
context).
Syntax
name vlan–name
no name
Parameter Description
Default Configuration
The default VLAN name is default.
Parameter Description
vlan–name The name of the VLAN. Must be 1–32 characters in length.
2CSPC4.X8100-SWUM100.book Page 801 Wednesday, August 29, 2012 6:23 PM