Command Line Interface Guide

806 VLAN Commands
Example
The following example shows how to display all interfaces for Double VLAN
Tunneling.
console#show dvlan-tunnel
Interfaces Enabled for DVLAN Tunneling......... 1/0/1
show dvlan-tunnel interface
Use the show dvlan-tunnel interface command in Privileged EXEC mode to
display detailed information about Double VLAN Tunneling for the specified
interface or all interfaces.
Syntax
show dvlan-tunnel interface {gigabithethernet unit/slot/port |
tengigabitethernet unit/slot/port | fortygigabitethernet unit/slot/port| all}
• all — Displays information for all interfaces.
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode, Config mode and all Config sub-modes
User Guidelines
This command has no user guidelines.
Example
The following example displays detailed information for port 1/0/1.
console#show dvlan-tunnel interface 1/0/1
Interface Mode EtherType
--------- ------- --------------
1/0/1 Enable vMAN
The following table describes the significant fields shown in the example.
2CSPC4.X8100-SWUM100.book Page 806 Wednesday, August 29, 2012 6:23 PM