Command Line Interface Guide

802.1x Commands 859
console(config-if-1/0/16)# dot1x timeout quiet-period
3600
dot1x timeout re-authperiod
Use the dot1x timeout re-authperiod command in Interface Configuration
mode to set the number of seconds between re-authentication attempts. To
return to the default setting, use the no form of this command.
Syntax
dot1x timeout re-authperiod seconds
no dot1x timeout re-authperiod
• seconds — Number of seconds between re-authentication attempts.
(Range: 300–4294967295)
Default Configuration
Re-authentication period is 3600 seconds.
Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
This command has no user guidelines.
Example
The following example sets the number of seconds between re-authentication
attempts to 300.
console(config)# interface gigabitethernet 1/0/16
console(config-if-1/0/16)# dot1x timeout re-
authperiod 300
2CSPC4.X8100-SWUM100.book Page 859 Wednesday, August 29, 2012 6:23 PM