Command Line Interface Guide

862 802.1x Commands
• seconds — Time in seconds that the switch should wait for a response to
an EAP-request/identity frame from the client before resending the
request.
(Range: 1–65535)
Default Configuration
The period of time is set to 30 seconds.
Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
Change the default value of this command only to adjust for unusual
circumstances, such as unreliable links or specific behavioral problems with
certain clients and authentication servers.
Example
The following command sets the number of seconds that the switch waits for
a response to an EAP-request/identity frame to 3600 seconds.
console(config)# interface gigabitethernet 1/0/16
console(config-if-1/0/16)# dot1x timeout tx-period
3600
show dot1x
Use the show dot1x command in Privileged EXEC mode to display:
• A summary of the global dot1x configuration.
• Summary information of the dot1x configuration for a specified port or all
ports.
• Detailed dot1x configuration for a specified port
• Dot1x statistics for a specified port, depending on the tokens used.
Syntax
show dot1x [interface interface-id [statistics]]
2CSPC4.X8100-SWUM100.book Page 862 Wednesday, August 29, 2012 6:23 PM