Command Line Interface Guide

802.1x Commands 877
Example
The following example set the unauthenticated VLAN on port 1/0/2 to VLAN
20.
console(config-if-1/0/2)#dot1x unauth-vlan 20
show dot1x advanced
Use the show dot1x advanced command in Privileged EXEC mode to display
802.1x advanced features for the switch or for the specified interface. The
output of this command has been updated in release 2.1 to remove the
Multiple Hosts column and add an Unauthenticated VLAN column, which
indicates whether an unauthenticated VLAN is configured on a port. The
command has also been updated to show the Guest VLAN ID (instead of the
status) since it is now configurable per port.
Syntax
show dot1x advanced [{gigabitethernet unit/slot/port| tengigabitethernet
unit/slot/port | fortygigabitethernet unit/slot/port}]
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode, Config mode and all Config sub-modes
User Guidelines
This command has no user guidelines.
Example
The following example displays 802.1x advanced features for the switch.
console#show dot1x advanced
Port Guest Unauthenticated
VLAN Vlan
--------- --------- ---------------
2CSPC4.X8100-SWUM100.book Page 877 Wednesday, August 29, 2012 6:23 PM