Command Line Interface Guide

890 Data Center Bridging Commands
Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
This command has no user guidelines.
Example
console#config
console(config)#interface range ethernet all
console(config-if)#datacenter-bridging
console(config-if-dcb)#priority-flow-control mode on
console(config-if-dcb)#priority-flow-control priority
1 no-drop
lldp dcbx version
Use the lldp dcbx version command in Global Configuration mode to
configure the administrative version for the Data Center Bridging Capability
Exchange (DCBX) protocol. This command enables the switch to support a
specific version of the DCBX protocol or to detect the peer version and match
it. DCBX can be configured to operate in IEEE mode or CEE mode or CIN
mode. In auto mode, version detection is based on the peer device DCBX
version. The switch operates in either IEEE or one of the legacy modes on
each interface.
NOTE: CIN is Cisco Intel Nuova DCBX (version 1.0). CEE is converged enhanced
ethernet DCBX (version 1.06).
Use the no form of the command to reset the dcbx version to the default
value of auto.
Syntax
lldp dcbx version {auto | cin | cee | ieee}
no lldp dcbx version
2CSPC4.X8100-SWUM100.book Page 890 Wednesday, August 29, 2012 6:23 PM