Command Line Interface Guide

FIP Snooping Commands 927
Parameter Description
Default Configuration
This command has no default configuration.
Command Mode
User EXEC, Privileged EXEC, Config mode and all Config sub-modes
User Guidelines
This command can only be entered after FIP snooping is enabled using the
feature fip-snooping command. Otherwise, it does not appear in the CLI
syntax tree.
The following information is displayed:
Parameter Description
Interface-id ID of an interface on which FIP snooping has been enabled.
FCF-MAC MAC address of the FCF that is part of the session.
ENode-MAC MAC address of the ENode that is part of the session.
VLAN ID number of the VLAN that contains the session.
FCoE MAC Source MAC address of the FCoE packets that are originated
by the ENode as part of the session.
FC-ID Fiber Channel ID of the virtual port that was created by the
FCF when the ENode VN_Port did a FLOGI/NPIV/FDISC
request.
Parameter Description
FCF-MAC MAC address of the FCF that is part of the session.
ENode-MAC MAC address of the ENode that is part of the session.
VLAN ID number of the VLAN that contains the session.
FCoE MAC Source MAC address of the FCoE packets that are originated
by the ENode as part of the session.
FC-ID Fiber Channel ID of the virtual port that was created by the
FCF when the ENode logged into the network.
2CSPC4.X8100-SWUM100.book Page 927 Wednesday, August 29, 2012 6:23 PM