Command Line Interface Guide

942 FIP Snooping Commands
Parameter Description
Default Configuration
This command has no default configuration.
Command Mode
User EXEC, Privileged EXEC, Config mode and all Config sub-modes
User Guidelines
This command can only be entered after FIP snooping is enabled using the
feature fip-snooping command. Otherwise, it does not appear in the CLI
syntax tree.
Example
console#show fip-snooping vlan 200
VLAN: 200
FC-MAP: 0E:FC:00
Number of FCFs discovered: 1
Number of ENodes discovered: 2
Total virtual sessions in VLAN: 3
Active Ports:
Te1/0/2, Te1/0/3,Te1/0/21
Parameter Description
vlan-id A VLAN enabled for FIP snooping.
VLAN VLAN in which FIP snooping is enabled/operational.
FC-MAP FCoE mapped address prefix of the FCoE forwarder for the
FCoE VLAN.
FCFs Number of FCFs discovered.
ENodes Number of ENodes discovered.
Sessions Total virtual sessions in FCoE VLAN.
2CSPC4.X8100-SWUM100.book Page 942 Wednesday, August 29, 2012 6:23 PM