Command Line Interface Guide

ARP Commands 965
Syntax
ip proxy-arp
no ip proxy-arp
Default Configuration
Enabled is the default configuration.
Command Mode
Interface Configuration (VLAN) mode
User Guidelines
The ip proxy-arp command is not available in interface range mode.
Example
The following example enables proxy arp for VLAN 15.
(config)#interface vlan 15
console(config-if-vlan15)#ip proxy-arp
show arp
Use the show arp command in Privileged EXEC mode to display all entries in
the Address Resolution Protocol (ARP) cache. The displayed results are not
the total ARP entries. To view the total ARP entries, the operator should view
the show ARP results.
Syntax
show arp [brief]
• brief — Display ARP parameters.
Default Configuration
This command has no default configuration.
2CSPC4.X8100-SWUM100.book Page 965 Wednesday, August 29, 2012 6:23 PM