Reference Guide

48 Fabric OS FCIP Administrator’s Guide
53-1002474-01
Creating a multicircuit tunnel (example)
2
3. Add circuits using the portcfg fcipcircuit command. The command requires the source and
destination IP addresses that you assigned to ports in step 1, as well as a bandwidth
assignments. The following example commands create six circuits for the FCIP tunnel that you
created in step 2. Each circuit provides a fixed 1000 Mbps (1 Gigabit) maximum usable
bandwidth.
Site A
Site A:
portcfg fcipcircuit 16 create 0 192.168.0.64 192.168.0.63 -b 1000000 -B
1000000
portcfg fcipcircuit 16 create 1 192.168.1.64 192.168.1.63 -b 1000000 -B
1000000
portcfg fcipcircuit 16 create 2 192.168.2.64 192.168.2.63 -b 1000000 -B
1000000
portcfg fcipcircuit 16 create 3 192.168.3.64 192.168.3.63 -b 1000000 -B
1000000
portcfg fcipcircuit 16 create 4 192.168.4.64 192.168.4.63 -b 1000000 -B
1000000
portcfg fcipcircuit 16 create 5 192.168.5.64 192.168.5.63 -b 1000000 -B
1000000
Site B
portcfg fcipcircuit 16 create 0 192.168.0.63 192.168.0.64 -b 1000000 -B
1000000
portcfg fcipcircuit 16 create 1 192.168.1.63 192.168.1.64 -b 1000000 -B
1000000
portcfg fcipcircuit 16 create 2 192.168.2.63 192.168.2.64 -b 1000000 -B
1000000
portcfg fcipcircuit 16 create 3 192.168.3.63 192.168.3.64 -b 1000000 -B
1000000
portcfg fcipcircuit 16 create 4 192.168.4.63 192.168.4.64 -b 1000000 -B
1000000
portcfg fcipcircuit 16 create 5 192.168.5.63 192.168.5.64 -b 1000000 -B
1000000
4. To display the results of creating the tunnel and circuits from the preceding steps, use the
portshow fciptunnel all -c command. Tunnel status for Site A and Site B displays the same.
portshow fciptunnel all -c
switch63:root> portshow fciptunnel all -c
-----------------------------------------------------------------------------
--
Tunnel Circuit OpStatus Flags Uptime TxMBps RxMBps ConnCnt CommRt Met
-----------------------------------------------------------------------------
--
16 - Up c------ 4m22s 0.00 0.00 1 - -
16 0 ge0 Up ---4--s 4m22s 0.00 0.00 1 1000/1000 0