Manualshelf

Reference Guide

ManualsBrandsDell ManualsComputer equipmentPowerConnect B-8000
61626364656667686970
Fabric OS FCIP Administrator’s Guide 49
53-1002474-01
Modifying an FCIP tunnel on a Brocade 7800 FX8-24 blade
2
16 1 ge1 Up ---4--s 4m12s 0.00 0.00 1 1000/1000 0
16 2 ge2 Up ---4--s 4m2s 0.00 0.00 1 1000/1000 0
16 3 ge3 Up ---4--s 3m50s 0.00 0.00 1 1000/1000 0
16 4 ge4 Up ---4--s 3m34s 0.00 0.00 1 1000/1000 0
16 5 ge5 Up ---4--s 2m10s 0.00 0.00 1 1000/1000 0
-----------------------------------------------------------------------------
--
Flags: tunnel: c=compression m=moderate compression a=aggressive compression
A=Auto compression f=fastwrite t=Tapepipelining F=FICON
T=TPerf i=IPSec l=IPSec Legacy
Flags: circuit: s=sack v=VLAN Tagged x=crossport 4=IPv4 6=IPv6
L=Listener I=Initiator
Modifying an FCIP tunnel on a Brocade 7800 FX8-24 blade
FCIP tunnel characteristics and options can be modified as needed, using the portCfg fcipTunnel
command with the modify option. The command syntax is as follows:
portCfg fciptunnel ve_port modify <options>
Where:
ve_port Each tunnel is assigned to a specific VE_Port. The VE_Port number serves as
the tunnel ID. The range is 16 through 23 for a 7800 switch and 12 through
31 for the FX8-24 blade.
<options> Options are as listed and described in Table 7 on page 40.
NOTE
When you use portcfg fciptunnel to modify the circuit options, the changes apply only to circuit
0.
CAUTION
Using the modify option may disrupt traffic on the specified FCIP tunnel for a brief period of time.
Modifying an FCIP circuit on a Brocade 7800 FX8-24 blade
FCIP circuit characteristics and options can be modified as needed, using the portCfg fcipcircuit
command with the modify option. The general command syntax is as follows:
portCfg fcipcircuit ve_port modify circuit_id <options>
Where:
ve_port Each FCIP tunnel is assigned to a specific VE_Port. The VE_Port number
serves as the tunnel ID. Specify the VE_Port of the tunnel that contains the
FCIP circuit you want to modify.
circuit_id The numeric ID assigned when the circuit was created.
<options> Options are as listed and described in Table 8 on page 42.