Setup Guide

Mid-Mount Rack Kit (Switch) Installation Procedure 7
53-1001791-01
FIGURE 3 Attaching front rails to a cabinet
Attaching rear brackets to a cabinet
Complete the following steps to attach the rear brackets to the cabinet.
1. Position the right rear bracket (Item 2) in the right rear of the switch (Figure 4).
2. Attach the brackets using three 6-32 x 1/4 in. screws (Item 4) and retainer nuts (Item 6).
3. Adjust the brackets to cabinet depth and tighten the Item 6 screws to a torque of 9 in.-lbs (10 cm-kgs).
4. Repeat step 1 through step 3 to attach the left rear bracket (Item 1).
1 Bracket, front righ 6 Retainer nut, 10-32
5 Screw, 10-32 x 5/8 in., panhead Phillips
6
1 5