Installation Manual

152 BigIron RX Installation Guide

53-1001811-01

Replacing cooling system components

FIGURE 77 Removing a BigIron RX-32 fan assembly

4. Insert the new fan assembly into the fan slot and push the assembly in until the face plate is

flush with the chassis. Pushing the fan assembly in seats the fan connector with the chassis

connector.

5. Secure the fan assembly to the chassis by replacing and tightening the four screws on the card

cage fan assemblies and the two screws on the power supply fan assemblies.

6. Check the fan status LED in the lower left corner of the face plate. It will be red momentarily

when power is applied, then change to green when the fan comes up to speed.

1 Fan module 1 6 Fan module 6

2 Fan module 2 7 Fan module 7

3 Fan module 3 8 Fan module 8

4 Fan module 4 9 Fan module 9

5 Fan module 5 10 Fan module 10