Installation Manual

BigIron RX Installation Guide 63
53-1001811-01
Installing a BigIron RX-32 switch
2
NOTE
When inserting the module into the chassis, make sure that the faceplate doesnot overlap with
the faceplate of an adjacent interface module.
5. Push the ejectors in until they are flush with the module front panel. This action will fully seat
the module in the backplane. Modules have a snug fit for maximum EMI protection.
FIGURE 42 Installing a module in a BigIron RX-32 chassis
NOTE
The installation instructions for installing modules shown in the following illustrations are
exactly the same for interface, management, and switch fabric modules.
6. Tighten the two screws at either end of the module front panel by pushing them in and turning
them clockwise. Then, tighten the screws further using the flat-head screwdriver.
Pwr
Activ e
Pwr
Acti ve
Pwr
Activ e
Pwr
Acti ve
Pwr
Activ e
Pwr
Activ e
Pwr
Acti ve
Pwr
Acti ve
Pwr
Acti ve