Instruction manual
10
Technical Support: support@wyrestorm.com US: +1 866 677 0053 EU: +44 (0) 1793 230 343
NHD-IP-CTL BROWSER CONFIGURATION & CONTROL
10. NHD-IP-CTL Browser Conguration & Control
Navigate to the switches web browser configuration interface and follow these steps:
Navigate to Network > IGMP Snooping > Advanced and set IGMP Snooping to Enable and select Apply.
In Network > IGMP Snooping > Advanced click the icon under Operation and in the following screen set both
IGMP Snooping and Querier to Enabled. Click Apply.
For any ports that have devices connected that are not NetworkHD components, including PC’s and third party
control systems navigate to Network > IGMP Snooping > Basic and select the port from the Port drop down menu,
Enable Fast Leave and click Apply.
Ensure that settings are all saved to the Boot ROM by pressing Save in the top right hand corner of the web UI.
Ensure all NetworkHD components are connected to the network and powered up correctly.
Attention If you receive a ‘server unavailable’ system message after entering this address into your
browser, ensure your PC is on the same subnet as the CTL box by following these steps:
Click Start menu, go to
Control Panel >
Network and Sharing center >
Change Adapter Settings >
Local Area Connection.
Right click and choose Properties.
1
Return to your browser and try entering the default IP again (192.168.11.243)
4
3
Hewlett Packard 1810 series switches
1
2
Check Use the following IP
address, for the IP address
enter 192.168.11.x (if unsure
use 192.168.11.5) Enter subnet
mask number 255.255.0.0
Click OK, then click OK again.
Highlight Internet Protocol
Version 4 (TCP/IPv4) then
click Properties
2 3