Instruction manual

13
Technical Support: [e-mail] US: [phone] EU: [phone]
NETWORKHD CONSOLE CONFIGURATION
iv. Commands
1. CTL Settings contains the settings for the IP control box itself, comprising of two separate network connections for
communication with RX/TX devices and communication to the PC/control system.
2. Each setting must be on the same subnet as other devices to enable communication between all devices.
3. The default Auto IP setting is recommended for RX & TX communication - devices will use Bonjour to discover each
other.
Attention Included in the download package is the Bonjour SDK installer. This must be installed prior to
installing the NetworkHD Console software.
i. NetworkHD Console Software Installation
Download the latest installation package of the NetworkHD Configuration Software from wyrestorm.com and
double-click NetworkHDConsole.exe to start the tool.
Attention Your operating System must be Windows XP or later.
The NHD-IP-TX & NHD-IP-RX are configured by default to IP addresses in the range of 169.254.xxx.xxx,
commonly referred to as Auto IP addresses. This is not a DHCP assigned address.
This addressing enables the NHD-IP-CTL to automatically discover NHD TX & RX units without any configuration on
any network. Changing an RX or TX devices IP settings will prevent this auto discovery and the system components will
require a reset.
NOTE The example below is based on operation using Windows 7 - steps may differ slightly depending on
your operating system.
Attention NetworkHDConsole.exe is Windows
only. For configuration from other operating systems
the NHD-IP-CTL must be used. If a ‘Windows
Security Alert’ appears, check both boxes and click
‘Allow access’ (with Administration Authority)
11. NetworkHD Console Conguration
1
2
GUI Element Description
Factory Default Restore TX/RX to factory default settings
Reboot Reboot TX/RX