Instruction manual
6
Technical Support: support@wyrestorm.com US: +1 866 677 0053 EU: +44 (0) 1793 230 343
CONNECTION
7. Connection
Attention Ensure good quality cabling is used throughout your system, with no electrical interference,
bends, twists, kinks, or other issues that may interfere with signal transmission, including the use of patch
panels or wall outlets. Cable connectors should also be in good condition and correctly terminated to
required standards, with straight cable runs used where possible and plugs securely connected to ports
without straining port enclosures.
The presence of any of these factors in your system can jeopardize successful signal distribution and
should be eliminated wherever possible.
Connect an HDMI source (such as Blu-ray, Satellite/Cable receiver, media server, computer etc.) to any
NHD-IP-TX transmitters to be used with a good quality HDMI cable, ensuring firm port connection.
Connect the computer to be used for KVM to the transmitter with a good quality USB cable.
Connect RS232 from the receiver to the display.
Connect an HDMI display to the receiver with a good quality HDMI cable.
Connect USB control devices (keyboard, mouse) to the USB of the receiver.
Connect good quality, well terminated CAT5e/6 cables of no more than 100m/328ft between the transmitter (TX),
receiver (RX) and Controller (CTL) - if in use.
2
3
4
5
6
1
Cat5e Wiring Guide
The quality of termination
for every RJ45 is
essential. Poor terminations leads to intermittent
performance and longer install times.
Cat5e/6 Cable Performance Guide
NHD-IP-TX & NHD-IP-RX
0ft 328ft32ft 65ft 98ft 131ft 164ft 197ft 230ft 262ft 295ft
0m 100m10m 20m 30m 40m 50m 60m 70m 80m 90m
1
2
Key
cat 5e/6
100m/328ft
hdmi
USB
RS232
Blu Ray
KVM
Controller
Tx rxTx rx
3 34 4
5 5
6
6
6
7 7
8