Reference Guide

IronWare Software Release 02.8.00a for Brocade BigIron RX Series Swtches
Release Notes v 1.0 Page 40 of 40
Defect ID: DEFECT000350901
Technical Severity: Medium
Summary: IPv6 SNMP-client not displayed in running configuration.
Symptom: Unable to add “snmp-client ipv6 2606:8200::ffff” to the configuration. When configuring the clause, the
system seemed to take the command without any warning, but running configuration did not appear to save it.
Feature: SNMP Management Function: CLI
Probability: High
Found in Release: RX 02.7.02
Service Request ID: 613853
Defect ID: DEFECT000279953
Technical Severity: Medium
Summary: STP BPDUs may be dropped across the Q-in-Q link
Feature: L2 Protocol Function: STP
Probability: Medium
Found in Release: RX 02.7.02 Service Request ID: 238581
Where Else Fixed: PATCH: RX 02.7.02 e
Defect ID: DEFECT000343291 Technical Severity: Medium
Summary: gig-default neg-off previously configured as gig-default auto-full does not activate link
Symptom: A “gig-default auto-full” configured port does not get to link up state if the other end of the link has “auto
negotiation” disabled on the port. To get the link up, must remove “gig-default auto-full” once and then add it
again.
Feature: SYSTEM
Function: Auto-negotiation
Probability: Medium
Found in Release: RX 02.7.02
Service Request ID: 555549