Owner's Manual

IronWare Software Release R04.2.00b for Brocade TurboIron 24X
Series Switches Release Notes v1.00 Page 17 of 22
Supported Layer 3 Features
Category, Description, and Configuration Notes
Supported
on
TurboIron
• Up to 255 virtual interfaces
VRRP
Yes
VRRP-E
Yes
Note: Layer 3 features not listed under “Layer 3 Features” are not supported.
Image Files for IronWare R04.2.00b
The following Software Image Files are available for IronWare R04.2.00b.
Device
Boot Image
Flash Image
TurboIron 24X Series GRZ04100.bin TIS04200b.bin (Layer 2)
TIR04200b.bin (Layer 3)
Factory Pre-loaded Software
This table lists the software that is factory-loaded into the primary and secondary flash areas on the
device. All images are included on the CD-ROM shipped with the device.
Model
Software Images
Primary Flash
Secondary Flash
TurboIron 24X Series Layer 2 Layer 2
Note: For Layer 3 image, go to myBrocade.com, click the Product Documentation tab, then click on the
link to the Knowledge Portal (KP). Download the image from the KP and follow the steps below to
upgrade the software image.
Upgrading software images
Upgrading the Boot Code
1. Place the new boot code on a TFTP server to which the Brocade device has access.
2. Enter the following command at the Privileged EXEC level of the CLI (example: FastIron
Switch#) to copy the boot code from the TFTP server into flash memory:
copy tftp flash <ip-addr> <image-file-name> bootrom
3. Use the copy tftp flash command to copy the boot code to the Brocade device only during a
maintenance window. Attempting to do so during normal networking operations can cause
disruption to the network.