Quick Reference Guide

PowerConnect B-Series TI24X Configuration Guide 273
53-1002269-02
Configuring IP subnet, IPX network andprotocol-based VLANs
10
Also suppose you want a single router interface to be present within all of these separate broadcast
domains, without using IEEE 802.1Q VLAN tagging or any proprietary form of VLAN tagging.
Figure 63 shows this configuration.
FIGURE 63 Protocol-based (Layer 3) VLANs
To configure the VLANs shown in Figure 63, use the following procedure.
1. To permanently assign ports 1 – 8 and port 25 to IP subnet VLAN 1.1.1.0, enter the following
commands.
PowerConnect> en
No password has been assigned yet...
PowerConnect# config t
PowerConnect(config)#
PowerConnect(config)# ip-subnet 1.1.1.0/24 name Green
PowerConnect(config-ip-subnet)# no dynamic
PowerConnect(config-ip-subnet)# static ethernet 1 to 8 ethernet 25
2. To permanently assign ports 9 – 16 and port 25 to IP subnet VLAN 1.1.2.0, enter the following
commands.
PowerConnect(config-ip-subnet)# ip-subnet 1.1.2.0/24 name Yellow
PowerConnect(config-ip-subnet)# no dynamic
PowerConnect(config-ip-subnet)# static ethernet 9 to 16 ethernet 25
3. To permanently assign ports 17 – 25 to IP subnet VLAN 1.1.3.0, enter the following commands.
PowerConnect(config-ip-subnet)# ip-subnet 1.1.3.0/24 name Brown
PowerConnect(config-ip-subnet)# no dynamic
PowerConnect(config-ip-subnet)# static ethernet 17 to 25
4. To permanently assign ports 1 – 12 and port 25 to IPX network 1 VLAN, enter the following
commands.
Port25
Port25
IP-Subnet 1
IP-Subnet 2
IP-Subnet 3
IPX Net 1
Appletalk Cable 100
IP-Subnet 1
IP-Subnet 2
IP-Subnet 3
Ports 1-16, 25
IPX Net 1
Ports 17-25
Appletalk Cable 100
Device
Layer 3 Switch