Quick Reference Guide

PowerConnect B-Series TI24X Configuration Guide 491
53-1002269-02
PIM Sparse
19
Displaying a list of multicast groups
To display a list of the IP multicast groups the Layer 3 Switch is forwarding, enter the following
command at any CLI level.
PowerConnect# show ip pim group
Total number of groups: 1
Index 1 Group 228.1.0.88
Group member at e2: v33 EX 0,
Group member at e13: v55 EX 0,
Group member at e1: v5 EX 0,
Syntax: show ip pim group
This display shows the following information.
Displaying BSR information
To display BSR information, enter the following command at any CLI level.
PIM Sparse interface information
NOTE: You also can display IP multicast interface information using the show ip pim interface command.
However, this command lists all IP multicast interfaces, including regular PIM (dense mode) interfaces.
The show ip pim sparse command lists only the PIM Sparse interfaces.
Interface The type of interface and the interface number. The interface type can be one of the
following:
• Ethernet
• VE
The number is either a port number or the virtual interface (VE) number.
TTL Threshold Following the TTL threshold value, the interface state is listed. The interface state can be
one of the following:
• Disabled
• Enabled
Local Address Indicates the IP address configured on the port or virtual interface.
TABLE 76 Output of show ip pim group
This field... Displays...
Total number of Groups Lists the total number of IP multicast groups the Layer 3 Switch is forwarding.
NOTE: This list can include groups that are not PIM Sparse groups. If interfaces on
the Layer 3 Switch are configured for regular PIM (dense mode) , these
groups are listed too.
Index The index number of the table entry in the display.
Group The multicast group address
Group member
Ports The Layer 3 Switch ports connected to the receivers of the groups.
TABLE 75 Output of show ip pim sparse (Continued)
This field... Displays...