Specifications

5
Figure 4. Mounting the fifth drive.
The fifth drive mounts on the smaller aluminum tray near the power supply. Remove the
four pancake-head machine screws and flip the tray towards the back of the unit. The clearance
between the cables for the 1st and 2nd drives and the small aluminum tray is insufficient, and
folding one of the four tabs to be parallel with the drive's side wall was necessary. In the figure
above, this is the circled area showing the tab already bent. Like the first four drives, four course
thread machine screws mount the drive to the tray, but in this case, they screw in to the side of the
drive as opposed to the bottom. These screws' positions are approximately indicated by the green
arrows.