CLI Reference Guide

1168 | show ntp peer Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide
show ntp peer
show ntp peer <a.b.c.d>
Description
Show NTP peer information.
Syntax
Parameter Description
<a.b.c.d>
IP address of an NTP peer
Usage guidelines
The show ntp peer command is used for NTP server troubleshooting, and should only be used under the supervision
of Dell technical support. Issue the show ntp servers command to view basic settings for currently configured NTP
servers.
Related Commands
To configure an NTP server, use the command ntp server.
Command History
This command was available in ArubaOS 3.0.
Command Information
Platforms Licensing Command Mode
All platforms Base operating system Enable and Config mode on local and master
controllers