CLI Reference Guide

ap mesh-cluster-profile
ap mesh-cluster-profile <profile>
clone <profile>
cluster <name>
no ...
opmode [opensystem | wpa2-psk-aes]
rf-band {a | g}
wpa-hexkey <wpa-hexkey>
wpa-passphrase <wpa-passphrase>
Description
This command configures a mesh cluster profile used by mesh nodes.
Syntax
Parameter Description Range Default
<profile>
Name of this instance of the profile. The name must be 1-
63 characters.
— “default”
clone
Name of an existing mesh cluster profile from which
parameter values are copied.
— —
cluster
Indicates the mesh cluster name. The name can have a
maximum of 32 characters, and is used as the MSSID for
the mesh cluster. When you first create a new mesh
cluster profile, the profile uses the default cluster name
“Dell-mesh”. Use the cluster parameter to define a new,
unique MSSID before you assign APs or AP groups to the
mesh cluster profile.
NOTE: If you want a mesh cluster to use WPA2-PSK-AES
encryption, do not use spaces in the mesh cluster name ,
as this may cause errors in mesh points associated with
that mesh cluster.
To view existing mesh cluster profiles, use the CLI
command show ap mesh-cluster-profile.
— “Dell-mesh”
no
Negates any configured parameter. — —
opmode
Configures one of the following types of data encryption.
l opensystem—No authentication or encryption.
l wpa2-psk-aes—WPA2 with AES encryption using a
pershared key.
Best practices are to select wpa2-psk-aes and use the
wpa-passphrase parameter to select a passphrase. Keep
the passphrase in a safe place.
opensystem
wpa2-psk-aes
opensystem
rf-band
Configures the RF band in which multiband mesh nodes
should operate:
a = 5 GHz
g = 2.4 GHz
Best practices are to use 802.11a radios for mesh
deployments.
a
g
a
wpa-hexkey
Configures a WPA pre-shared key. — —
wpa-passphrase
Sets the WPA password that generates the PSK. — —
Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide ap mesh-cluster-profile | 127