CLI Reference Guide

Parameter Description Range Default
cellular_nw_preference
g-only|4g-only|
advanced|auto
The Cellular Network Preference setting introduced in
ArubaOS 6.2.1.0 allows you to select how the modem
should operate.
l auto (default): In this mode, modem firmware will
control the cellular network service selection; so the
cellular network service failover and fallback is not
interrupted by the remote AP (RAP).
l 3g_only: Locks the modem to operate only in 3G.
l 4g_only: Locks the modem to operate only in 4G.
l advanced: The RAP controls the cellular network
service selection based on an Received Signal
Strength Indication (RSSI) threshold-based approach.
Initially the modem is set to the default auto mode.
This allows the modem firmware to select the
available network. The RAP determines the RSSI
value for the available network type (for example 4G),
checks whether the RSSI is within required range,
and if so, connects to that network. If the RSSI for the
modem’s selected network is not within the required
range, the RAP will then check the RSSI limit of an
alternate network (for example, 3G), and reconnect to
that alternate network. The RAP will repeat the
above steps each time it tries to connect using a 4G
multimode modem in this mode.
link-priority-cellular <link-
priority-cellular>
Change the FQDN or IP address for the master controller. — —
set <masterstr>
Specify the or IP address or FQDN for the master
controller.
— —
clear
Clear the definition for the master controller in this
profile.
— —
no
Negates any configured parameter. — —
pppoe-passwd
Point-to-Point Protocol over Ethernet (PPPoE) password
for the AP.
— —
pppoe-service-
name
PPPoE service name for the AP. — —
pppoe-user
PPPoE username for the AP. — —
remote-ap
Specifies that the profile is to be associated with a
remote AP using certificates.
— —
reprovision
Provisions one or more APs with the values in the
provisioning profile.
— —
reset-bootinfo
Restores factory default provisioning parameters to the
specified AP.
NOTE: This parameter can only be used on the master
controller.
— —
uplink-vlan <uplink-vlan>
If you configure an uplink VLAN on an AP connected to a 0 ( 0
Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide ap provisioning-profile | 139