CLI Reference Guide

uplink
crypto-local
uplink {cellular priority <prior>}|disable|enable|{wired priority <prior>}|{wired vlan <id>}
Description
Manage and configure the uplink network connection on the W-600 seriescontrollers.
Syntax
Parameter Description Range
cellular priority <prior>
Set the priority of the cellular uplink. By default, the cellular uplink
is a lower priority than the wired uplink; making the wired link the
primary link and the cellular link the secondary or backup link.
Configuring the cellular link with a higher priority than your wired
link priority will set your cellular link as the primary controller link.
1-255
enable
Enable the uplink manager.
—
disable
Disable the uplink manager.
—
wired priority <prior>
Set the priority of the wired uplink. Each uplink type has an
associated priority; wired ports having the highest priority by
default.
1-255
wired vlan <id>
Define the VLAN identification (ID) of the uplink VLAN . A maxmim
of four wired VLANs can be defined
1-4094
Usage Guidelines
The W-600 seriescontrollers supports multiple 3G cellular uplinks in addition to its standard wired ports, providing
redundancy in the event of a connection failure. If an W-600 series’ wired link cannot access the internet, the
controller can fail over to a secondary cellular link and continue routing traffic.
Command History
Release Modification
ArubaOS 3.4 Command introduced
ArubaOS 6.0 The wired prority parameter was introduced.
Command Information
Platforms Licensing Command Mode
W-600 seriescontrollers Base operating system Config mode on master and local controllers
Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide uplink | 1435