CLI Reference Guide

Parameter Description Range Default
ipsec
Configures IPsec. This configuration must match the
IPsec parameters configured with the crypto dynamic-
map and crypto ipsec commands on the controller.
— —
encryption
Specifies the encryption type for IPsec, either DES or
3DES.
esp-3des |
esp-des
esp-3des
hash
Specifies the hash algorithm used by IPsec, either MD5
or SHA.
esp-md5-
hmac | esp-
sha- hmac
esp-sha-
hmac
lifetime
Specifies how long an IPsec security association lasts,
in seconds.
300-86400 7200 seconds
pfs
Specifies the IPsec Perfect Forward Secrecy (PFS)
mode, either group 1 or group 2.
group1 |
group2
group2
no
Negates any configured parameter. — —
ppp authentication
Enables the protocols for PPP authentication. This list
should match the L2TP or PPTP configuration
configured with the vpdn command on the controller.
— —
cache-securid
The controller caches Secure ID tokens so that the user
does not need to reauthenticate each time a network
connection is lost.
— disabled
chap
Use CHAP with PPP authentication. — enabled
mschap
Use MSCHAP with PPP authentication. — enabled
mschapv2
Use MSCHAPv2 with PPP authentication. — enabled
pap
Use PAP with PPP authentication. — enabled
Usage Guidelines
A VPN dialer is a Windows application that configures a Windows client for use with the VPN services in the
controller. When VPN is used as an access method, a user can login using captive portal and download a VPN dialer.
You can customize a VPN dialer for a user role configured with the user-role command. After the user authenticates
via captive portal, a link appears to allow download of the VPN dialer if a dialer is configured for the user role.
Example
The following command configures a VPN dialer:
(host) (config) #vpn-dialer default-dialer
ike authentication pre-share f00xYz123BcA
Command History
The command was introduced in ArubaOS 3.0.
Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide vpn-dialer | 1461