CLI Reference Guide

Syntax
Description Range Default
<profile-name>
Name of this instance of the profile. The name must be
1-63 characters.
— “default”
902il-compatibility-
mode
(For clients using NTT DoCoMo 902iL phones only)
When enabled, the controller does not drop packets
from the client if a small or old initialization vector
value is received. (When TKIP or AES is used for
encryption and TSPEC is enabled, the phone resets the
value of the initialization vector after add/delete
TSPEC.)
NOTE: This parameter requires the PEFNG license.
— disabled
a-basic-rates
List of supported 802.11a rates, in Mbps, that are
advertised in beacon frames and probe responses.
6, 9, 12,
18, 24, 36,
48, 54
Mbps
6, 12, 24 Mbps
a-beacon-rate
Sets the beacon rate for 802.11a (use for Distributed
Antenna System (DAS) only). Using this parameter in
normal operation may cause connectivity problems.
default, 6,
9, 12, 18,
24,36,48,54
Mbps
minimum valid
rate
a-tx-rates
Set of 802.11a rates at which the AP is allowed to send
data. The actual transmit rate depends on what the
client is able to handle, based on information sent at
the time of association and on the current error/loss
rate of the client.
6, 9, 12,
18, 24, 36,
48, 54
Mbps
6, 9, 12, 18, 24,
36, 48, 54 Mbps
advertise-ap-name
If enabled, APs that are part of this VAP willbroadcast
the AP Name information in the beacons frames.
— —
advertise-location
If enabled, APs that are part of this VAP will broadcast
their GPS coordinates in the beacons and probe
response frames as part of a vendor-specific Infor-
mation Element.
— disabled
ageout
Time, in seconds, that a client is allowed to remain
idle before being aged out.
1000 seconds
battery-boost
Converts multicast traffic to unicast before delivery to
the client, thus allowing you to set a longer DTIM
interval. The longer interval keeps associated wireless
clients from activating their radios for multicast
indication and delivery, leaving them in power-save
mode longer and thus lengthening battery life.
NOTE: This parameter requires the PEFNG license. This
parameter should not be enabled if you plan on using
the Push-To-Talk feature for Polycom SpectraLink
devices.
— disabled
clone
Name of an existing SSID profile from which
parameter values are copied.
— —
deny-bcast
When a client sends a broadcast probe request frame — disabled
Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide wlan ssid-profile | 1501