CLI Reference Guide

Parameter Description Range Default
rf-band For APs that support both a and b/g RF bands, RF band
in which the AP should operate:
l g = 2.4 GHz
l a = 5 GHz
a/g g
rtls-server Enables the AP to send RFID tag information to an RTLS
server.
— —
ip-addr IP address of the server to which location reports are
sent.
— —
port Port number on the server to which location reports are
sent.
— —
key Shared secret key. — —
station-message-
frequency
Indicates how often packets are sent to the server. 5-3600 30 seconds
session-acl Session ACL configured with the ip access-list session
command.
NOTE: This parameter requires the PEFNG license.
— —
syscontact SNMP system contact information. — —
telnet Enable or disable telnet to the AP. — disabled
Usage Guidelines
The AP system profile configures AP administrative operations, such as logging levels.
Example
The following command sets the LMS IP address in an AP system profile:
(host) (config) #ap system-profile local1
lms-ip 10.1.1.240
Command History
Release Modification
ArubaOS 3.0 Command introduced
ArubaOS 3.2 Support for additional RTLS servers and remote AP enhancements was introduced.
ArubaOS 3.3.2 l Maintenance-mode parameter was introduced.
l Multiple remote AP DHCP server enhancements were introduced.
l Support for RFprotect server and backup server configuration was introduced.
l The mms-rtls-server parameter was deprecated in ArubaOS 3.3.2.
ArubaOS 5.0 The master-ip, rfprotect-server-ip and rfprotect-bkup-server parameters were deprecated.
ArubaOS 6.0 Added support for the option to set the RF scanning band (am-scan-rf-band).
The keepalive-interval parameter was deprecated.
Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide ap system-profile | 159