CLI Reference Guide

168 | audit-trail Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide
audit-trail
audit-trail [all]
Description
This command enables an audit trail.
Syntax
Parameter Description
all
Enables audit trail for all commands, including enable mode commands. The audit-trail
command without this option enables audit trail for all commands in configuration mode.
Usage Guidelines
By default, audit trail is enabled for all commands in configuration mode. Use the show audit-trail command to
display the content of the audit trail.
Example
The following command enables an audit trail:
(host) (config) #audit-trail
Command History
This command was introduced in ArubaOS 3.0.
Command Information
Platforms Licensing Command Mode
All platforms Base operating system Config mode on master controllers