CLI Reference Guide

240 | database synchronize Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide
database synchronize
database synchronize {[period <minutes>][rf-plan-data]}
Description
This command manually synchronizes the database between a pair of redundant master controllers and includes RF
Plan data when synchronizing with standby.
Syntax
Parameter Description
period
Configures the interval for automatic database synchronization.
<minutes>
Interval in minutes. Range is 1 — 25200 minutes.
rf-plan-data
Includes the RF Plan data when synchronizing with standby mode.
Usage Guidelines
This command takes effect immediately. If a peer is not configured, the controller displays an error message.
Use the database synchronize period command in config mode to configure the interval for automatic database
synchronization. Use the database synchronize rf-plan-data command to include RF plan data when synchronizing
in standby mode.
Example
The following commands cause the database on the active master controller to synchronize with the standby in 25
minute intervals. The synchronization includes RF plan data.
(host) (config) #database synchronize period 25
(host) (config) #database synchronize rf-plan-data
Command History
This command was introduced in ArubaOS 3.0.
Command Information
Platforms Licensing Command Mode
All platforms Base operating system Enable and Config modes on master
controllers