CLI Reference Guide

Parameter Description
n internal: Then remote node IP will be derived from the
remote node DHCP pool.
n pppoe: Use PPPoE to obtain IP address
For details on using this command,
see "interface fastethernet | gigabitethernet" on page 314
ip
Configure the Interface Internet Protocol configuration sub commands.
For details, see command descriptions beginning with "ip default-
gateway" on page 358.
l default-gateway
l domain lookup
l domain-name
l name-server
l nat
l radius
l route
ipv6
Configure the Global IPv6 configuration sub commands. For details,
see command descriptions beginning with "ipv6 enable" on page 342.
l enable
l route X:X:X:X::X/<0-128>
logging
Set the logging level up to which messages are logged.
l A.B.C.D
l facility
l level
For details on using this command, see "logging" on page 426
mgmt-server
Register Mgmt Server IP Address with the controller.This could be
AirWave Management Server or any other server that would like to
receive messages from the controller using AMON protocol. For
details on using this command, see "mgmt-server" on page 440.
mgmt-user
Configure a management user. For details on using this command, see
"mgmt-user" on page 441.
mobility-manager
Configure a mobility manager. For details on using command, see
"mobility-manager" on page 444.
model <model_type>
Controller model associated to the Remote Node profile, where
<model-type> is one of the following controller model types:
l W-3200
l W-3400
l W-3600
l W-620
l W-650
no
Delete a remote node profile.
priority-map <name>
Priority Map specification, used to prioritize the incoming packets on
an interface. For details on using this command, see "priority-map" on
page 481.
remote-node-dhcp-pool <pool_name>
Name of the DHCP pool.
pool-type {vlan <id>}|tunnel
Specify whether you are creating a pool of IP addresses for RN VLANs
Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide remote-node-profile | 505